- FUJIFILM PC AUTOSAVE NOT WORKING HOW TO
- FUJIFILM PC AUTOSAVE NOT WORKING INSTALL
- FUJIFILM PC AUTOSAVE NOT WORKING PASSWORD
- FUJIFILM PC AUTOSAVE NOT WORKING PC
FUJIFILM PC AUTOSAVE NOT WORKING PASSWORD
Now, having defined name and password of the Wi-Fi, we have to tell Windows that it should setup such network. This my network is just for demonstration and will never be used again, so my password is simple and I can show it here: We want our network to be secure – this will be a network offered by our own PC, so nobody except of us should be able to connect to it. The second thing we need to define is the network access password. So for use in this article, I have defined the network name to be
FUJIFILM PC AUTOSAVE NOT WORKING PC
You need this step only if you want to create separate Wi-Fi network, supplied by your PC instead of home access point.įor this step we need to define (or invent) two things: name of the network – it must be meaningful to us as we will need to find it later on in the crowd of other available networks. Note: you DON’T need to do this step if you use the home Wi-Fi network. The following steps need to be done only once.
FUJIFILM PC AUTOSAVE NOT WORKING HOW TO
OK, so how to set up the communication? I use Windows 10, so it will be how to do it in case of Windows 10.įirst we need to enable a hot-spot, offered by our PC and enable PC to communicate with X-Pro2. Unless your PC is based on motherboard with integrated Wi-Fi, like for example ASUS X99 DELUXE I use.
FUJIFILM PC AUTOSAVE NOT WORKING INSTALL
But if you use desktop PC, probably it does not have any Wi-Fi module, so you need to buy one and install it. Please note – if you use notebook, you already have the needed Wi-Fi hardware. So I have enabled the Wi-Fi module built into my PC’s motherboard. In addition I prefer setting up a dedicated Wi-Fi network, just for Fuji, network I enable when needed and disable when not needed. But my PC is connected with cable to the switch, so the Wi-Fi communication between X-Pro2 and my PC didn’t work. So if we have a PC connected via Wi-Fi to the access point, it should work fine. I have observed this problem when PC was connected to the external switch as well as when the PC was connected with Ethernet cable to the switch built into the access point. It seems to be very similar to the Nikon UT-1 with WT-5 – in both cases I observed the same problem. I have checked it on my own – if X-Pro2 is connected to the access point but the PC is connected with Ethernet cable to the switch and then from switch to the access point, the communication will not work. When we use the existing home network, one thing is very important: due to poor Wi-Fi implementation in X-Pro2, both X-Pro2 and the PC must be connected directly to the same access point. For this purpose we can use either a home Wi-Fi or… we can create separate Wi-Fi network, served by the PC instead of home Wi-Fi access point and dedicated just for Fuji data transmission. I know that some people have issues establishing the connectivity with existing network, so here are some instructions, discoveries and thoughts.įirst thing: what network to connect to? This article is limited (by design) to only one option: transmitting the data from the body to the PC. I definitely prefer using Wi-Fi for this task. I use this option all the time as I don’t like removing cards from the body, guessing what is on which card, shuffling them in the reader.
0 kommentar(er)
